Advertisement
KB100-ST
Please Note: To assure proper installation, it is suggested that a qualified person or carpenter install
the Koala Baby Changing Station. Koala Kare Products will not be responsible if the station is not
installed properly. Koala Baby Changing Stations have been tested to hold a substantial static load. The
unit must be attached to a permanent wall that is capable of holding a substantial load. The maximum
recommended total weight for this baby changing station (including baby and parcel bag) is 60 lbs.
Excessive weight may cause a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child's midsection, and push
spring tabs into buckle until both spring tabs lock in place with an audible "click". Straps can be adjusted
to make strap tighter or looser as required.
Inspection Criteria:
A properly maintained baby changing station should be inspected on a daily basis and parts replaced if
they do not pass inspection criteria.
• Has a pneumatic shock that controls the smooth opening and closing of the unit. Shock may need
replacement if door opens or closes too rapidly or door doesn't close completely.
• Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached to
unit at both ends.
• Has a warning label affixed to the product.
• Offers parents liners through a fully stocked liner dispenser. (If model includes a dispenser built into unit.)
• Provides a clean changing surface for customers to attend to their children.
Visit koalabear.com to view list of replacement parts and videos.
gloves
level
KB110-SSRE
&
Tools Needed
drill
1/8" (3 mm)
(regular
masonry)
&
drill bits
Hardware Provided
four 1/4"x 3" (6 mm x 76 mm)
Phillips panhead wood screws
Operating Instructions
stud finder
Phillips head
screwdriver
measuring
tape
pencil
four ¼" (6 mm)
flat washers
Advertisement
