Koala Kare KB111-SSRE Installation Instructions

Vertical Recessed Mounted Baby Changing Station
KB111-SSRE
INSTALLATION INSTRUCTIONS
Please Note:
To assure proper installation,
it is suggested that a
qualifi ed person or carpenter
install the Koala Baby
Changing Station. Koala
Kare Products will not be
responsible if the station is
not installed properly.
Koala Baby Changing
Stations have been tested
to hold a substantial static
load. The unit must be
attached to a permanent wall
that is capable of holding a
substantial load.
You are responsible for the safe operation of this unit.
Inspection Criteria:
A properly maintained unit:
• Opens and closes smoothly.
• Has both ends of a functioning, non-frayed
strap: buckle clicks when closed and strap is
attached at both ends of the unit.
• Offers parents liners through a fully stocked
liner dispenser. (Dispenser is built into unit.)
• Provides a clean, convenient place for
customers to attend to their children.
Your unit can be installed to meet ADA regulations when and where applicable.
Refer to Federal Register, Volume 56, No. 144 28 CFR Part 36.
Tools Needed:
• Measuring Tape
• Level
• Flat Head and Phillips
Screwdrivers
• Stud Finder
• Pencil
• Drill
• 7/32" (.56 cm) Drill Bit
(regular and masonry)
• 1/8" (.32 cm) Drill Bit
(regular and masonry)
• ½" (1.27 cm) Drill Bit
(regular and masonry)
To order replacement parts call
888.733.3456, 303.539.8300, or visit
www.koalabear.com.
•
•
•
•
•
•
•
Hardware Supplied:
• Four ¼" x 3" (.64 cm x
7.62 cm) Panhead Wood
Screws
• Four ¼" x 3" (.64 cm x
7.62 cm) Phillips Panhead
Machine Screws
• Four ¾" x ¼" (2 cm x .64
cm) Hole Washers
• Four Toggles
• One Restroom Sign
Vertical Strap (885)
Vertical KB111-SSRE Gas Shock (877)
Grey Vertical Liner Dispenser Lid (827)
Koala Restroom Door Decal (841)
Warning Label (975)
Grey Unit End Caps (850)
Box of Liners (KB150-99)