List Of Xclarity Controller Events - Lenovo ThinkSystem SR650 V2 Reference

Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPUN0019M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
FQXSPUN0020N Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
FQXSPUN0023N Sensor [SensorElementName] has transitioned to non-recoverable.
FQXSPUN0050M The RAID controller in PCI slot [arg1] is in critical state. At least one
logical drive is offline.
FQXSPUN0053M The RAID controller in PCI slot [arg1] is in critical status. At least one
physical drive is failed.
FQXSPUN0054M The RAID controller in PCI slot [arg1] is in critical status. At least one
logical drive is now degraded or partially degraded.
FQXSPUN0055M The RAID controller in PCI slot [arg1] is in critical state. Battery is in
non-optimal state.
FQXSPUP0007L Invalid or Unsupported firmware or software was detected on system
[ComputerSystemElementName].
FQXSPUP4000I Please ensure that the Management Controller [arg1] is flashed with
the correct firmware. The Management Controller is unable to match
its firmware to the server.
FQXSPUP4003I [arg1] firmware mismatch internal to system [arg2]. Please attempt to
flash the [arg3] firmware.
FQXSPUP4004I XCC firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the XCC firmware to the same level on all
nodes/servers.
FQXSPUP4005I FPGA firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the FPGA firmware to the same level on all
nodes/servers.

List of XClarity Controller events

This section lists all messages that can be sent from the XClarity Controller.
• FQXSPBR4000I: Management Controller [arg1]: Configuration restored from a file by user [arg2].
This message is for the use case where a user restores a Management Controller configuration from a file.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0027
User Action:
Information only; no action is required.
• FQXSPBR4001I: Running the backup Management Controller [arg1] main application.
This message is for the use case where a Management Controller has resorted to running the backup
main application.
22
ThinkSystem SR650 V2 Messages and Codes Reference
Severity
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error