Primera LX600 User Manual page 29

There are three sensor modes:
Die-Cut (Default). If you are using standard die-cut labels that look similar to the graphic, use this
setting regardless of the size of the label. Also, use this setting for Through-hole label material
where a hole is punched through each label or a notch is cut in the side.
Reflective. Use Reflective for label material where a black pre-printed line (black mark) on the back
of the label stock indicates the break between labels. Black marks are required on clear label stock
rolls, or label where the label waste matrix (waste) is left on the liner. Black marks can also be used
for irregular shaped labels, circles larger than 4 inches or on any stock where the print starting
position cannot be sensed using the label itself.
Continuous. (Sensor off) If you have continuous stock with no die-cut, reflective mark or holes, set
the sensor type to Continuous. This will turn off the stock sensor. In this mode there is no way to set
the print starting position. The printer will simply start printing the first label and print each
subsequent label immediately after that previous one. To produce a gap between prints simply add
the desired amount of white space to the end of the label being printed. The printer will
automatically switch to this setting when Digital Die Cutting Label Stock is installed.
Important Note: You must also set the Stock Sensor Position (Section 2D)
29