Set Server Parameter Values - Vivotek sd6112v User Manual

Set Server Parameter Values

Note: This request require administrator access
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/admin/setparam.cgi?
[nosync=<value>&]<parameter>=<value>
[&<parameter>=<value>...][&return=<return page>]
parameter value
0, 1
nosync
<group>_<name>. value to assigned Assign
<return page>
return
description
Specifies that there should be no sync (write) of
the corresponding configuration file on flash. If
parameter is omitted, a sync write will occur.
(note: this parameter must be put at begin of
parameter list)
<value>
<group>_<name>..
Redirect to the page <return page> after the
parameter is assigned. The <return page> can be
a full URL path or relative path according the the
current path. If you omit this parameter, it will
redirect to an empty page.
(note: The return page can be a general HTML
file(.htm, .html) or a Vivotek server script
executable (.vspx) file. It can not be a CGI
command. It can not have any extra parameters.
This parameter must be put at end of parameter
list)
- 72 -
to the parameter
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532