Using The System - Viper 5501 Owner's Manual

Using the system

Please note the screen shot to the right of a feature indicates what the display
looks like when this feature is activated.
Lock
Command
: Press one time to Lock
Feedback
:
Notes
:
A U X
Details
: The horn in the vehicle "honks" once. (if the op-
tion is installed), and the parking lights flash one time. If the power door locks
have been connected, the doors lock.
When panic is activated the horn horns if connected an the parking lights flash
for 30 sec. Panic mode can be disabled by pressing (icon) lock or unlock.
The system automatically checks for errors when it locks. The 2-way remote
"beeps" once and the parking lights flash once to confirm locking. If no lock
confirmation is received, the remote LC displays the out-of-range signal.
If errors are found when locking:
If the door was open at the time of locking, you are notified of this active zone
immediately after locking the system.
The horn in the vehicle "honks" again. The 2-way remote control sounds a short
"error" tone, and the LCD displays the door icon.
Locking without the honk (Silent Lock)
X
A U
Press the button on the remote once, and then press the
locks without the confirmation honk. The parking lights flash once. The 2-way re-
mote displays the
emits the Out Of Range signal.
© 2008 Directed Electronics. All rights reserved.
Lock Icon appears, and parking lights
flash once.
Press/hold for 1.5 seconds to Lock the
system and activate the panic feature.
icon. If no lock confirmation is received, the 2-way remote
AUX
button. The system
AUX
15