Lighting Instructions - Napoleon LEX Series Manual

Table of Contents

Advertisement

Available languages

Available languages

Lighting Instructions

WARNING!
WARNING!
valve.
1. Open grill lid.
2. Push and turn any main burner knob slowly
to the 'hi' position. This action will ignite the
pilot flame which will in turn light the selected
burner. If the pilot lights, continue to push
down on the control knob until the burner
lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob back to the
'off position and repeat step 2 several times.
4. If the pilot and burner will not ignite within
5 seconds, turn the control knob to the 'off'
position and wait 5 minutes for any excess gas
to dissipate. Either repeat steps 2 and 3 or
light with a match.
5. If lighting the unit with a match, clip the
match into the supplied lighting rod. Hold the
lit match down through the grill and sear plate
while turning the corresponding burner valve
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
N415-0434 MAY 28.18
Lights
Left
Left Centre
Burner
Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas supply
Main Burner
Lighting
3. Push and turn the rotisserie burner
control knob slowly to the 'hi' position.
This action will ignite the pilot flame which
will in turn light the burner. If the pilot
lights, continue to push down on the burner
control knob until the burner lights then
4. If the burner does not ignite, then imme-
diately turn the control knob back to the 'off'
position and repeat step 3 several times.
5. If the burner will not ignite within 5
seconds, turn the control knob to the 'off'
position and wait 5 minutes for any excess
gas to dissipate. Either repeat steps 3 and 4
to high.
The propane cylinder is equipped with an excess flow device. Unless all burners are
Do not use the rear burner (rotisserie burner) with the main burners operating.
Lighting Hole
Right
Right Centre
Burner
Burner
Rear Burner Lighting
(Rotisserie Burner)
(if equipped)
1. Open grill lid.
2. Remove the warming rack.
release.
or light with a match.
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
2. Push and turn side burner control to
high position.
3. Press and hold igniter button until
burner lights, or light by match.
4. If the burner will not ignite within 5
seconds, turn the control knob to the
'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat
steps 2 and 3 or light with a match.
www.napoleongrills.com
7
EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bilex485Bilex485pss1Bilex485nss1

Table of Contents