Connecting Your Monitor - Iiyama ProLite LE4262S-1 User Manual

CONNECTING YOUR MONITOR

Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer with the USB Cable from the Monitor.*
Connect the Power Cable to the monitor fi rst and then to the power supply.
Turn on your monitor (Main Power Switch and Power Switch) and computer.
 The signal cables used for connecting the computer and monitor may vary with the type of
NOTE
computer used. An incorrect connection may cause serious damage to both the monitor and
the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector.
If a special cable is required please contact your local iiyama dealer or regional iiyama
offi ce.
 For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama offi ce for a suitable adaptor.
 Make sure you tighten the fi nger screws at each end of the Signal.
 Don't connect the RS-232C cable and the USB cable to the computer at the same time.
And cannot use those at the same time.*
[Example of Connection]
AV Equipment
Computer
* Available for ProLite TE4262MTS only.
16 BEFORE YOU OPERATE THE MONITOR
HDMI Cable
(Not Included)
Audio Cable
(Not Included)
DVI-D Cable
(Accessory)
D-Sub Signal Cable (Accessory)
USB Cable *
<Back>
Power Cable
(Accessory)