Advertisement
G
Only use the appliance for its intended
domestic use. Kenwood will not accept any
liability if the appliance is subject to improper
use, or failure to comply with these
instructions.
before plugging in
G
Make sure your electricity supply is
the same as the one shown on the
underside of the appliance.
Important - UK only
G
The wires in the cord are coloured
as follows:
Blue = Neutral
Brown = Live.
G
The appliance must be protected by
a 13A approved (BS1362) fuse.
Note:
G
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
G
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
G
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
Use your blender for soups, drinks,
pâtés, mayonnaise, breadcrumbs,
biscuit crumbs, chopping nuts and
crushing ice.
before using for the first time
G
Wash the parts: see 'care and
cleaning'.
key
filler cap
lid
goblet
sealing ring
blade unit
base
speed + pulse control
power unit
cord storage
to use your blender
1 Fit the sealing ring
unit
- ensuring the seal is located
correctly in the grooved area.
G
Leaking will occur if the seal
is damaged or incorrectly
fitted.
2 Clip the blade unit
.
3 Screw the blade assembly onto the
goblet – ensuring the blade
assembly is fully tightened.
4 Put your ingredients into the goblet.
Never blend more than 1.2
litres or more than 800 ml for
frothy liquids like milkshakes.
5 Fit the filler cap to the lid.
6 Fit the lid by pushing down until
secure.
7 Place the blender onto the power
unit.
G
The appliance won't work if
the blender is incorrectly
fitted.
8 Select a speed (refer to the
recommended speed chart).
4
into the blade
into the base
Advertisement
