Table of Contents
Advertisement
Understanding the basics
Connecting a home theater system
Connecting using a digital audio cable
To connect using a digital coaxial cable:
1 Make sure that your TV's power cord is unplugged and the home
2 Connect one end of a digital
the DIGITAL AUDIO OUT jack on the back of the TV.
Home theater
system
3 Connect the other end of the audio cable to the digital
input jack on the home theater system.
To play TV sound through a home theater system:
1 Turn on the TV and select a program to watch.
2 Turn on the home theater system and select the TV sound source,
then adjust the volume to a comfortable level.
Connecting headphones
Warning: When using headphones, adjust the headphone volume to
avoid excessively loud volume which can damage your hearing.
To connect headphones:
Plug the headphones (not included) into the
jack on the back of the TV.
Note: The TV sound automatically mutes when headphones are
connected.
PC IN
DIGITAL
PC AUDIO IN
VGA
AUDIO OUT
Connecting devices with USB interface
P
g u l
h t
U e
B S
i t s
i k c
o t n
1. The USB detect message will pop out when you plug in USB stick
into TV. Select "OK" to review content on USB.
2. Or you can press INPUT button on the remote control or on the TV
and select DMP in source list.
coaxial
audio cable (not included) to
DIGITAL
AUDIO OUT
Digital
coaxial
cable
(headphone)
VIDEO
L
R
HDMI 2
RJ12
AUDIO
USB
AV IN
OUT
S U
p B
t r o
n o
h t
s e
e d i
f o
. V T
PC IN
PC AUDIO IN
Understanding the basics
1 Plug the power cord into an AC power outlet.
2 Press
3
goes into standby mode.
Warning: When your TV is in standby mode, it is still receiving power. To
completely disconnect power, unplug the power cord.
Note: If your TV does not receive an input signal for several minutes, it
automatically goes into standby mode.
Selecting the video input source
coaxial
To select the video input source:
1 Turn on your TV, then press INPUT on the remote control or on
the TV. The INPUT SOURCE menu opens.
2 Press or to highlight the video source you want, then press
ENTER
HDMI,DMP.
Selecting a channel
Tip: If you are using a cable or satellite box, use the remote control that
came with that device to change channels.
To select a channel:
Press CH
Press the number buttons to enter the channel number you want,
then wait for the channel to change, or press ENTER to change
the channel immediately.
To select a digital channel, press the number buttons to
select the main digital channel, then press the dash(-). button,
then the number buttons again to select the sub-channel.
Wait for the channel to change or press ENTER to change the
channel.
Note: Button presses must be within three seconds of each other.
Press LAST to go to the last channel viewed.
Press GUIDE to display a list of memorized channels, press or
to select the channel you want from the list, then press ENTER to
go to that channel.
Note: If the list has more than one page, press
the pages.
Adjusting the volume
To adjust the volume:
Press VOL
Press MUTE
to restore the sound.
DIGITAL
HDMI 2
RJ12
AUDIO
USB
VGA
AUDIO OUT
OUT
(power). Your TV turns on.
. Options include TV,Video,Component,PC(computer),
/CH
to go to the next or previous channel.
/VOL
to increase or decrease the volume.
9
VIDEO
L
R
AV IN
or
to scroll through
MUTE again
Advertisement
Table of Contents
