Table of Contents
Advertisement
NOTE:
► The Preset Positions will also be displayed on the home page. Select one from the Go to drop-down
list, and the Network Camera will move to the selected preset position.
► Click Patrol: The Network Camera will patrol along the selected positions repeatedly.
PTZ
Mechanical PTZ Operation
Select the "Mechanical" tab to display the RS485 Settings:
RS485 Settings
Disable: Select this option to disable this function.
PTZ camera: Select this option to enable PTZ operation.
To utilize this feature, please connect the Network Camera to a PTZ driver or scanner via RS485 serial
interface first. Then you can configure the PTZ driver and RS485 port with the following settings.
VIVOTEK provides the following PTZ drivers: DynaDome/SmartDOME, Lilin PIH-7x00, Pelco D, and
Pelco P protocol. If none of the above PTZ drivers is supported by your PTZ scanner, please select
Custom camera (scanner). Please refer to the documentation of your PTZ scanner to determine the
Camera ID, PTZ driver, and Port settings. The Camera ID is necessary to control multiple cameras. If you
click Save to enable this function, the camera control panel will be displayed on the main page. Please
refer to the illustration on page 56.
VIVOTEK
User's Manual - 119
Advertisement
Table of Contents
