Advertisement
■ Removing
a Press the lock with your finger (a) and pull docomo
mini UIM card out 2-3 mm toward b
b Lift your finger from the lock, press docomo mini UIM
card lightly and slide it toward b
･
Do not press docomo mini UIM card downward
forcefully.
Lock
b
✔INFORMATION
･
When handling docomo mini UIM card, take care not to
touch or scratch the IC part. Note that inserting docomo
mini UIM card forcibly into the terminal may damage
docomo mini UIM card.
◆ Security codes of docomo mini UIM
card
Two security codes, "PIN1 code" and "PIN2 code", are set
for docomo mini UIM card. The security codes are set to
"0000" by default, which you can change by yourself.→P37
Battery pack
◆ Attaching/Removing battery pack
･
Attach/Remove the battery pack after turning OFF the
power.
･
When you attach/remove the back cover, hold the
terminal in your hand so that you will not scratch the
a
display etc.
･
If the terminal gets wet, wipe off water before removing
the back cover.
･
Use Battery back F23 dedicated to the terminal.
■ Attaching
a Put your fingernail into the back cover removing part
a and lift the back cover vertically until the one side
goes off
25
Back cover removing part
Before using the terminal
Advertisement
