Monte Carlo Fan Company Loft 96 6LFR96 Series Owner's Manual And Installation Manual page 3

1
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Use AC 120V/60HZ power supply
only.
4
Blade bracket
Place motor assembly on a suitable area
of Styrofoam and
Install blade brackets.
Insert blade bracket into the slots on
flywheel, aligning the holes on blade bracket
with the screw holes on flywheel (
and bottom sides
), and then partially
install set screws provided.
Tighten set screws securely once the blade
bracket is installed in position with the set
screws.
Note: Make sure the side with a label
"This side up" is installed upward.
© 2020 Monte Carlo Fan Collections
2
Before installing this fan make sure the
outlet box is properly installed to the
house structure. To reduce the risk of
fire, electric shock, or personal injury,
mount to outlet box or supporting system
acceptable for fan support.
(Mounting must support at least 35 lbs.)
5
This side up
Top plate
Partially loosen the 3 set screws on the
yoke as shown in the illustration.
Install a top plate. Place top plate over lead
wires and safety cable. Align the 3 key
holes on the plate with the preinstalled
both top
screws on yoke and turn clockwise till tight.
Tighten screws securely.
3
Use metal outlet box suitable for fan
support and use only the screws provided
with the outlet box (must support 35 lbs).
Before attaching fan to outlet box, ensure
the outlet box is securely fastened by at
least two points to a structural ceiling
member (a loose box will cause the fan to
wobble). Remove the two outlet box
screws provided with the box, aligning
the holes of the mounting bracket with
the holes of the outlet box. Reinstall the 2
outlet box screws securely.
6
Remove preassembled keeper pin and
cross pin from downrod. Keep parts.
3
Mounting bracket
Downrod
Keeper pin
Cross pin
1/2020