Maintenance; Removing The Tilt Stand - Toshiba TLP-ET1E Owner's Manual

Maintenance

Removing the tilt stand

Do not remove the tilt stand unless when you replace the lamp or mount the projector on a ceiling. Removing
the tilt stand leaves the projector unstable and may block the air intake at the bottom. Usually, the projector
must be used with the tilt stand.
PRECAUTIONS
• Before removing the tilt stand, be sure to turn off the power and unplug the power cord.
Place the unit upside down.
Loosen the three screws.
Detach the tilt stand.
2
1
To put the tilt stand back in place, take the above steps in reverse order. At this time, always make sure that
the three screws have been tightened.
Turn the projector over and place it carefully. It is
recommended to lay a soft cloth, such as a thick towel,
under the unit to prevent it from shaking or getting
scratched.
Position the tilt stand where you can see three screws in
the centers of their respective screw holes. Loosen the
screws by turning them counterclockwise several times.
Hold the tilt stand with both hands, turn it
counterclockwise, then lift it to remove.
39