Table of Contents
Advertisement
Sensor (Input) connection
Connect one of the signal cables (2 cables) of various
sensors (IR sensor, heat ray detector, magnetic etc.) to the
COM port and connect the remaining signal cable to the
sensor number you want. (Sensor "NC, NO" type can be set
from "Setup
Event
Ò
NOTE
NC and NO cannot be selected simultaneously.
About internal hard disk
The hard disk installed inside the device is a precision device which can be damaged even with the
small impact. To prevent the hard disk from being damaged, manage the device as follows.
To prevent the data loss, it is recommended to back up any important data into an external storage
device. When installing or uninstalling the hard disk, you must always turn off the power of the
product.
•
If the power is turned on, do not move the device.
•
Do not install this device where it is too hot and humid and where the temperature change is
sudden. It can cause a problem to the device.
•
DO NOT pull out the plug or intercept the power supply while this device's power is on.
•
When there is a power outage while the power is turned on, some data can be lost.
•
Do not drop the hard drive or put any metallic object, such as coins, inside the device.
•
In case of a power outage while recording, avoid adding, replacing or moving the HDD. The
recorded data can be lost. In this case, turn on the power with the original hard disk that was
used while the power outage occurred. And then add, replace or move the HDD.
•
Because the hard disk is a high precision device, the parts inside the disk can be damaged at
the slightest impact. Please read the following precautions in detail and follow the directions.
-
Do not directly put the hard disk on the desk or table. Because the parts inside the hard
disk can be damaged at the slightest impact, put a thick cushion below the hard disk.
-
If you use the motored driver, the parts inside the hard disk can be damaged from the
vibration.
-
When replacing the hard disk, be careful not to cause any impact to the other parts.
Sensor" menu.)
Ò
Before use
1
Sensor input 1
2
Sensor input 2
3
Sensor input 3
4
Sensor input 4
G
Ground
5
Sensor input 5
6
Sensor input 6
7
Sensor input 7
8
Sensor input 8
G
Ground
17
2
Advertisement
Table of Contents
