Table of Contents
Advertisement
20
Before use
3. After removing all of power/SATA cable connected to hard disk, please separate hard disk
bracket from the body.
4. Loosen the screws on the left and right side of the bracket holding the hard disk.
5. Separate the hard disk from the bracket holding the hard disk.
6. In the reverse order of removing the hard disk, assemble the new hard disk.
7. After replacing the hard disk, turn on the power of the device.
8. Reference
2
-
Each SATA cable must be connected to the connecting port precisely.
-
Do not vertically put the hard disk in upright position or put other objects on top of the
hard disk.
-
When connecting/disconnecting the hard disk, do not use a motored tool.
-
Refer to the following when adding/replacing the hard disk.
Connecting E-SATA HDD
•
Turn off the power of DVR then connect E-SATA HDD to E-SATA port. And turn on the power of
E-SATA HDD first then turn on the power of DVR.
•
E-SATA HDD is used only for recording, it cannot be used for any other purpose like backup, for
example.
Recommended list of hard disk
Hard disks of below are the ones proved to be compatible through experiment.
Please refer to when adding or replacing the hard disk.
Capacity
250 GB
500 GB
1 TB
CAUTION
When you select the hard drive in use for resetting, the video data saved previously will be
deleted. Therefore you must be careful.
LE6016
ST3250310CS
ST3250312CS
ST3500312CS
ST3100322CS
Seagate
Advertisement
Table of Contents
