Installing A Memory Module - Toshiba QOSMIO G50 User Manual

Point to note about memory module error
If you install a memory module that is not compatible with the computer, the
Power indicator will flashes (on for 0.5 seconds, off for 0.5 seconds) in the
following ways;
If there is an error in only Slot A or no memory module is inserted in
Slot A: repeatedly flashes orange twice, then white.
If there is an error in Slot B: repeatedly flashes orange, then white
twice.
If there are errors in both Slot A and Slot B: repeatedly flashes orange
twice, then white twice.
In all instances you should shut down the computer and remove the
incompatible module(s).
Use a point size 0 Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.

Installing a memory module

The computer contains slots for two memory modules, one positioned
immediately over the other - the procedures are the same for installing
either module.
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
5. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
Screw
User's Manual
Turning off the power
Figure 9-6 Removing the memory module cover
section in Chapter 3,
section in Chapter 6, Power, if required).
Qosmio G50
Getting Started, if
Memory module cover
9-9