Cleaning And Care; Changing The Bulbs - Gaggenau AH 198-150 Operating And Installation Instruction

Cleaning and care

Switch off the extractor hood and isola-
te by pulling out the mains plug or swit-
ching off the disconnector on the instal-
lation side.
At the same time as you renew the
grease filter (see Filters and
maintenance), clean off any grease from
all accessible parts of the housing.
This significantly reduces the fire hazard
and ensures that the extractor hood
performs as effectively as possible.
Clean the extractor hood with a hot
detergent solution or a mild window
cleaning agent.
If the hood is extremely dirty (older
stains), use a liquid window cleaner.
Do not scratch off dried-on dirt, but
wipe off with a damp cloth.
Do not use scouring agents.
Warning: Clean the control buttons with a
mild detergent solution and a soft, damp
cloth only.
Painted, aluminium and plastic surfaces:
Do not use scouring agents or abrasive
sponges.
Do not use dry cloths.
Do not use corrosive, acidic or alkaline
cleaning agents.
Note: Do not use alcohol (spirit) on
plastic parts, otherwise the surface may
become matt in appearance.
Caution! Ensure that the kitchen is ade-
quately ventilated. Avoid naked flames.

Changing the bulbs

1. Switch off the extractor hood and isolate
by pulling out the mains plug or swit-
ching off the disconnector on the instal-
lation side.
2. Remove the filter frame.
See grease filter.
3. Replace the bulb (standard filament
bulb, max 40 W, E14 bulb holder).
4. Attach the filter frame.
See grease filter.
21