Table of Contents
Advertisement
User
User
Manual
Manual
10/100M adaptive Ethernet interface. Through this interface, IPCAM can be connected with various network
devices, such as hub, router, etc.
2 Reset button
Press and hold on the reset button for 5 seconds. Releasing the reset button, the password will back to the
factory default administrator password. The default administrator user is admin with no password.
3 Power Interface
Connect the external power adapter, request for 12V/2A or 12V/1A power.
1.4.3 Bottom View
There are up to two labels located at the bottom of the camera, this is an important feature of original cameras.
If your camera does not have labels, it may be a clone. Cloned cameras can not use original firmware and are
not eligible for warranty or technical services.
1.5 Wall installation
Figure 1.3
Step 1: Screw the mount on the wall with the 3 screws provided.
Step 2: Install the camera on the mounting bracket with 1 screw to complete installation.
NOTE:
Ensure that the rain or water will not reach the connector ports at the end of the pig tail wiring. These
connectors are not weather-resistant.
2 Access the IP Camera
5
Advertisement
Table of Contents
