Majestic JADE42IN Owner's Manual page 16

• Wait five minutes to allow possible accummulated gas
to clear.
• Remove decorative front from appliance.
• Locate reset switch inside the appliance. See Figure
3.8. Switch is located above the "RESET" label. Hold
reset switch down for one second and release. A
"beep" will signal module is reset.
Appliances with Wall Switch and Remote
• Turn wall switch back to "ON" position.
main menu on remote control and restart fireplace.
The fireplace will start as it would under normal
circumstances.
Appliances with Wall Switch Only:
• Turn wall switch back to "ON" position. The fireplace
will ignite as it would under normal circumstances.
Appliances with Remote Only:
• Turn fireplace back on using the main menu on the
remote control. The fireplace will ignite as it would
under normal circumstances.
• Reinstall decorative front on appliance.
• If the IFT-ECM re-enters the LOCK-OUT condition
after this procedure, contact your dealer for service.
RESET SWITCH
Figure 3.8 Reset Switch Location
16
Majestic • JADE32IN, JADE42IN, JADE42IL Owner's Manual • 2491-987 Rev. F • 9/18
Appliance ON/OFF:
A wall control, thermostat or remote control may be used
to control the ON/OFF function of the appliance. Follow
instructions included with the installed control.
Optional LED's
• LED's are an option on JADE32IN, JADE42IN and
JADE42IL appliances.
• The optional LED's must be used in conjunction with
the IFT-RC400 remote control. The intensity of the
these lights is controlled through the RC400 remote
Go to
control.