Optional Accessories; Cleaning And Maintenance; Ec Declaration Of Conformity - Bresser FM Series Instruction Manual

(see optional accessories) from our range, you can run the
flash with the included power cord without problems.
15. Low voltage protection
The low voltage protection will be activated if ...
... you work in 220-240V AC alternating current mode but the
current operating voltage is below 200V.
... you work in 100-130V AC alternating current mode but the
current operating voltage is below 100V.
„E0" appears on the LCD and charge display
addition, an audible signal is triggered. All this means that the
studio flash can not be charged and therefore can't work.
NOTE!
Make sure to use a power supply according to the given ranges!

Optional accessories

Wireless remote control WT-3/WT-3i
Art. No. F001840 / F003190 + F003234
- LCD display, 2.4GHz wireless (up to 50 meters), with USB-A plug
- Wireless control to set the flash power, synchronous triggering
- 2 operation modes (A and B), up to 100 devices can be
operated in each mode, up to 200 devices overall, free from
interference
- Shortest shutter synchronization: 1/200 sec.
Lithium accumulator
Art. No. F001844 / F001845
- Ideal for outdoor photography as an independent power
supply
- Suitable for flashes with a power up to 500Ws
- Simple operation with the normal power cord; no adapter or
additional cord neccessary
- Can also be used for charging your mobile phone or notebook
with an integrated 5V DC Output with USB port
Much more accessories such as light modifiers, tripods and
bags available in our webshop at www.photostudio.equipment

Cleaning and maintenance

Before cleaning the device, disconnect it from the power supply
(remove plug or remove batteries)!
Only use a dry cloth to clean the exterior of the device. To avoid
damaging the electronics, do not use any cleaning fluid.
Protect the device from dust and moisture. Store it in the
supplied bag or transportation packaging. The batteries should
be removed from the unit if it has not been used for a long time.
flashes. In
Disposal
Dispose of the packaging materials properly, according to
their type, such as paper or cardboard. Contact your local
waste-disposal service or environmental authority for information
on the proper disposal.
Do not dispose of electronic devices in the household
garbage!
As per Directive 2002/96/EC of the European Parliament on
waste electrical and electronic equipment and its adaptation
into German law, used electronic devices must be collected
separately and recycled in an environmentally friendly manner.
Please take the current legal regulations into account when
disposing of your device. You can get more information on
the proper disposal from your local waste-disposal service or
environmental authority.

EC Declaration of conformity

Bresser GmbH has issued a "Declaration of Conformity"
in accordance
corresponding standards. This can be viewed any time upon
request.
with applicable guidelines
DE
GB
and
15