Power Indicator; Using Power Management; Aspect - NEC MultiSync P404PG User Manual

Power Indicator

LED indicator
status and Condition
lighting pattern
Glowing blue Normal
1
Blinking green* Meeting one of the conditions
below when the monitor has
been past a certain amount of
time with no signal input which
you set.
• The monitor is with an option
board.
• INPUT DETECT is set to a
setting except for NONE.
• USB POWER is set to ON.
• DisplayPort is set to MST.
Glowing amber The monitor has been past a
certain amount of time with
[network signal input] + [no
AV signal input which you set].
Blinking amber The monitor has been past a
certain amount of time with
[network signal input] + [no
AV signal input which you set].
Glowing red Turn off the monitor by the
remote control or the monitor
button.
*1: Time setting for AUTO POWER SAVE is available at POWER SAVE
(See page 40).
NOTE: If the indicator is glowing a combination of long
and short in red, a certain failure might have
occurred, please contact your supplier.

Using Power Management

This LCD monitor follows the VESA approved DPM Display
Power Management function.
The power management function is an energy saving
function that automatically reduces the power consumption
of the monitor when the keyboard or the mouse has not been
used for a fi xed period.
This allows your LCD monitor to enter a Power Management
mode if the monitor's POWER SAVE function is set to
ENABLE then a certain amount of time is past since the
monitor recognized "no signal input". It will increase the life
and decrease the power consumption of the monitor.
NOTE: Depending on the computer and display card
used, this function may not operate.
After the video signal was lost, the monitor
automatically goes into OFF at a preset time
period.

Aspect

For MP, VIDEO
Recovery
FULL
For DVI, DisplayPort1, DisplayPort2, VGA (RGB), OPTION*
FULL
For VGA (YPbPr), HDMI1, HDMI2
FULL
1. Turn on the monitor
by the remote
control or the
*1: This function depends on which option board you are using.
monitor button.
2. Send an AV signal
Aspect ratio
input to the monitor.
of image
Turn on the monitor by
the remote control or
the monitor button.
Squeeze
Letterbox
NORMAL: Reproduces the aspect ratio that is sent from the
source.
FULL: Fills the entire screen.
WIDE: Expands a 16:9 letter box signal to fi ll the entire
screen.
DYNAMIC: Expands a 4:3 pictures to fi ll the entire screen
with non-linearity. Some of the outside image area will be cut
off due to expansion.
1:1: Shows the image in a 1 by 1 pixel format.
ZOOM
The image can be expanded beyond the active screen area.
The image which is outside of the active screen area is not
shown.
English-20
ZOOM NORMAL
1:1 ZOOM NORMAL
WIDE DYNAMIC 1:1
3
Unchanged view*
4:3
3
* Grey areas indicate unused portions of the screen.
ZOOM
1
ZOOM NORMAL
Recommended selection
3
for picture aspect*
NORMAL
DYNAMIC
FULL
WIDE
ZOOM