NEC MultiSync P404PG User Manual page 55

Mail Setting
Click on "MAIL" on the left column below HOME.
This option notifi es your computer about an error message via e-mail when using wired LAN. An error message will be sent
when an error occurs in the monitor.
ALERT MAIL Selecting [ENABLE] will turn on the Alert Mail feature.
Selecting [DISABLE] will turn off the Alert Mail feature.
STATUS MESSAGE Selecting [ENABLE] will turn on the STATUS MESSAGE feature.
Selecting [DISABLE] will turn off the STATUS MESSAGE feature.
SENDER'S ADDRESS Type in the sender's address. Up to 60 alphanumeric and symbols characters can be used.
SMTP SERVER Type in the SMTP server name to be connected with the monitor.
Up to 60 alphanumeric characters can be used.
RECIPIENT'S Type in your recipient's address. Up to 60 alphanumeric and symbols characters can be used.
ADDRESS 1 TO 3
AUTHENTICATION This selects the authentication method of the email transmission.
METHOD
POP3 SERVER This specifi es the address of the POP3 server that is used in the authentication of the email.
USER NAME This sets the user name for logging into the authentication server when authentication is required
for the email transmission. Up to 60 alphanumeric characters can be used.
PASSWORD This sets the password for logging into the authentication server when authentication is required for
the email transmission. Up to 60 alphanumeric characters can be used.
TEST MAIL Click on this button to send a test email to check if your settings are correct.
NOTE: • If you execute a test, you may not receive an Alert email.
Should this happen, check whether the network settings are correct.
• If you entered an incorrect address in a test, you may not receive an Alert email.
Should this happen, check whether the Recipient's Address is correct.
HINT: For the control command diagram, please see the fi le "External_Control.pdf" on the CD-ROM supplied with this
monitor.
Alert error message list
Error number
Alert mail Message
* ErrorCode
The monitor's power supply is not
70h ~ 7Fh
functioning normally.
80h ~ Fh The cooling fan has stopped.
The monitor's backlight unit is not
90h ~ 9Fh
functioning normally.
A0h ~ AFh The monitor is overheated.
A2h
The monitor does not receive an input
B0h ~ BFh
signal.
The remaining capacity of the error log
D0h
decreased.
The battery for clocks is empty.
D1h
E0h ~ EFh A system error occurred in the monitor.
Explanation
Standby power abnormal
Cooling fan abnormal
Backlight abnormal
Temperature abnormal
A Sensor reached the temperature limit
which was specifi ed in the OSD.
*Condition: DISPLAY PROTECTION-FAN
CONTROL-COOLING FAN = AUTO
No signal
The Proof of Play log memory size is
1 more hour.
The battery is empty.
System error.
English-53
Measure
Please contact your supplier.
Please contact your supplier.
Please contact your supplier.
Please contact your supplier.
Reconfi rm the settings in the OSD
(DISPLAY PROTECTION-FAN
CONTROL) or please contact your
supplier.
Please check "No picture" in
"Troubleshooting".
Please get a log by using PD external
command. See page 55.
Please connect the monitor to the
power then recharge the battery.
Please set (DATE & TIME) in OSD.
Please contact your supplier.