Car Seat/Stroller Assembly; Opening Stroller; Front Wheel Assembly; Locking Footrest - Century 4-in-1 system Instruction Manual

Stroller Right
Side

Opening Stroller

1
Stand stroller upright and pull tab to
release latch.
2
Raise napper bar over lower edge of seat
and push into slots.
NOTE: Stroller may be used without
napper bar raised. If using stroller
without napper bar raised, skip step 2.
3
Spread handle and rear legs until both
fold locks "click" into position.
3

CAR SEAT/STROLLER ASSEMBLY

Stroller Left
Side
Fold Locks

Front Wheel Assembly

1
Hold swivel wheel assembly upright
(tab pointing down).
2
Tilt stroller slightly back and push wheel
assembly onto leg until it locks in
place.
Repeat steps 1 and 2 for opposite leg.
CAUTION: After wheel assembly is complete, pull on
wheels to check that they are locked in place.

Locking Footrest

Push footrest down so that frame cross tube
is centered between three (3) tabs on
bottom of footrest until it snaps in place.

Rear Wheel Assembly

1
Remove axle protectors from ends of axle and discard.
2
With stroller laying face down on
floor, slide brake lever brackets onto
rear legs until your hear a click.
NOTE: Brake lever must face stroller
handle.
3
With connector ribs facing out, push
connector onto wheel ribs.
Tab
Tabs
Connector
Ribs
Wheel
Ribs