Table of Contents
Advertisement
Preparing the machine
Thread / cones / spools
The anti-vibration cone should
be used with the wider edge at
the bottom on the spool holder
pin when sewing with cones.
Household spools
Remove the anti-vibration
cones. Place spools on spool
holder pins and push the spool
caps on with the rounded side
downwards.
Using the machine
Power/light switch
The power/light switch is conveniently placed on the handwheel side of
the machine in front of the socket.
O = Off
I = On with light
CAUTION:
Perform these following steps when you are not using your sewing
machine.
1. Be sure to turn OFF the power switch.
2. Be sure to remove the power plug from the wall outlet.
3. Do not place a thing on the foot controller.
Two step presser foot
To raise the presser foot, lift the presser foot lever on the rear of the
machine, until it engages (A). It can be raised again to the maximum
height and held in this position to provide more space between presser
foot and stitch plate.(B).
Note: When the presser foot is raised, all the tensions are released
making it easier to thread the machine.
"WARNING"
When using the extra lift (B), do not run the machine or turn the hand-
wheel.
Large spools
If large industrial spools are used,
position the anti-vibration cone up-
side down on the spool holder pin,
i.e. with the wider edge at the top.
Thread nets
If the threads slip and gets twist-
ed, cover the spools of upper and
lower looper with the nets supplied
in the accessory bag.
8
Advertisement
Table of Contents
