Advertisement
Protection), ANSI Z89.1 (Head Protection), ANSI Z41.1 (Foot Protection)
and ANSI S12.6 (S3.19) (Hearing Protection).
•
Do not wear loose fitting clothing, jewelry or gloves with cut or frayed
fingers when operating the tool. Entanglement, choking, scalping and
laceration can occur if loose clothing, personal jewelry, neck wear, hair
or gloves are not kept away from the rotating tool and it's accessories.
Gloves can become entangled with the rotation drive, causing severed
or broken fingers.
M003
Wear Ear
Protection
Protection
Sound
•
Exposure to high noise levels can cause permanent, disabling hearing
loss and other problems, such as tinnitus (ringing, buzzing, whistling
or humming in the ears). Use hearing protection in accordance with
employer's instructions and as required by occupational health and
safety regulations. Appropriate controls to reduce the risk can include
actions such as damping materials to prevent work pieces from
"ringing".
•
Use and maintain as recommended in the manual to prevent an
unnecessary increase in noise levels.
Vibration
•
When using a rotary or percussive tool to perform work related
activities, the operator can experience discomfort in the hands, arms,
shoulders, neck or other parts of the body.
•
If you experience numbness, tingling, pain or whitening of the skin
in your fingers or hands, stop using the tool. Tell your employer and
consult a physician.
•
Wear warm clothing when working in cold conditions and keep your
hands warm and dry.
•
Exposure to vibration can cause disabling damage to the nerves and
blood supply of the hands and arms.
•
Do not use worn or ill-fitting sockets or extensions, as this is likely to
cause a substantial increase in vibration.
•
Do not touch sockets or accessories during impacting. This increases the
risk of cuts, burns or vibration injuries.
•
Use and maintain as recommended in the manual to prevent an
unnecessary increase in vibration.
•
Check the vibration level after each service. If higher than normal,
contact your STANLEY dealer.
Hydraulic
•
Warning: Hydraulic fluid under pressure could cause skin injection
injury. Do not check for leaks with your hands. If you are injured by
hydraulic fluid, get medical attention immediately.
•
Do not let hydraulic oil get on the skin. Hydraulic oil is hot. Wear
Personal Protection Equipment (PPE) at all times.
•
If exposed to hydraulic fluid, wash hands immediately.
•
Do not exceed the maximum relief valve setting stated on the tool.
•
Inspect and clean couplers before use, daily. Replace damaged couplers
immediately.
•
Hydraulic circuit control valve must be OFF before coupling or
uncoupling tools. Failure to do so may damage the couplers and cause
overheating of the hydraulic system.
•
Ensure the couplers are properly connected and are tight.
•
Do not operate the tool at fluid temperatures above 140°F (60°C).
Higher temperatures can cause operator discomfort and damage to the
tool.
•
Do not exceed the rated flow and pressure as stated on the tool. Rapid
failure of the internal seals may result.
10 | ID07 User Manual
M004
M016
Wear Eye
Wear a Mask
Advertisement
