Activate The Wireless Link - Philips SWW1810/27 User Manual

Activate the wireless link

Switch on the transmitter and receiver
In standby mode, a red power LED displays on
the transmitter and receiver. You can then turn on
the transmitter and receiver in the following ways:
• Press on the remote control.
» Both the transmitter and receiver are
turned on.
• Press on the transmitter and receiver.
Establish the link between the
transmitter and receiver
A flashing blue power LED displays until
the signal link between the two units are
established. Normally, it takes around 15-20
seconds for the link to establish successfully.
EN
12
Select the source on the transmitter
Press the source buttons on the remote
control, transmitter or receiver until you see the
available video from your device.
Tip
•
For information on the LED indicator status, see the
section on 'LED indicator status of the transmitter'.
LED indicator status of the
transmitter and receiver
Power Source Mode and status
LED LED
Solid Off Standby mode: it is a
red power-saving mode
Flashing Flashing Start up in progress: It takes
blue blue 15-20 seconds.
Flashing Flashing Searching available channels:
blue It occurs when the link
cannot establish over 80
seconds after initialization.
Solid Flashing On mode but without
blue quickly input from the source
device
Solid Flashing On mode with
blue slowly unrecognized video format
Solid Solid On mode with recognized
blue blue video format
Note
•
If the link is not established after 80 seconds, move the
transmitter, receiver and HDTV closer to each other.
The maximum transmission range is up to 65 feet (19.7
meters).
•
If more than one set of Philips Wireless HD AV Connect
is placed in the same room, make sure that the minimum
distance among each one is 6 feet 6 inches (2 meters).
•
If using a computer, make sure the video format is
supported before the video is displayed, see the
chapter on 'Technical data' for information.
•
If using a computer, and the picture on your TV is
not full screen, see the chapter on 'Frequently asked
questions' for information.