Electrolux E24ID74QP Use & Care Manual page 7

E n e r g y O p t i o n S e l e c t i o n s
Hi-Temp
When HI-TEMP option is selected, the dishwasher
heats water in the main wash to approximately
0 0
140 F (60 C).
This increase in water temperature helps
dishwasher detergent remove food, grease and soil
from dishes more effectively and aids in drying. HI-
TEMP option can only be used with AUTO, HEAVY,
NORMAL and UPPER cycles.
Sanitize
To sanitize your dishes and glassware, select the
SANITIZE option. This option heats the water
temperature in the fi nal rinse to 157
and maintains that temperature for 7 minutes.
SANITIZE is available in Auto, Heavy, and Normal
cycles. Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120 0 F (49 0 C).
If the SANITIZE option is selected, the pad
illuminates with a blue light. The sanitization
criteria may not be satisfi ed if there is an
interruption of the cycle, a power failure occurs,
or if incoming water temperature is below 120
(49 0 C).
Sanitize pad fl ashes at the end of the cycle if the
NSF requirements for sanitization are not reached.
Child Lock Controls/Air Dry
To prevent children from accidently changing the
dishwasher cycle or starting the dishwasher, lock
the dishwasher controls by pressing the AIR DRY
pad until " " shows in the status window. The
controls are locked and no new selections can
be made until the lock is released. To unlock
the controls, press the AIR DRY pad until "
disappears. If child lock is activated the dishwasher
will not work.
Operating Instructions
Max Dry
MAX DRY is available on Auto, Heavy, Normal,
Upper and Stemware cycles The cycle time will
increase when MAX DRY option is selected.
O p e r a t i o n S e l e c t i o n
Delay
The Delay Start option allows you to automatically
delay starting your dishwasher from 1 to 24 hours.
Press DELAY pad until the desired delay time
shows in the Status window then press START
0 F (69.4 0 C)
to confi rm the delay time. Press START again
and close door to activate. Display will indicate
the delay start time and will countdown until cycle
starts.
To cancel the DELAY option and begin the cycle
before the delay period is over, press the CANCEL
pad and then the START pad.
Start
To start a cycle, press the START pad once and
close the door.
0 F
Cancel
To cancel a cycle at anytime, open the door and
press the CANCEL pad until the 1 min drain feature
is initiated. Close the door and the drain cycle
will begin. You will hear a tone for the start and
completion of the drain cycle. When the door is
opened, the last cycle selected will be displayed.
If desired, a new cycle can now be selected and
upon closing the door the cycle will begin.
NOTE
Opening the door during normal operation will
"
only pause the selected cycle.
7