Advertisement
Connect the provided power t-harness@i .. -------------
9.
according to the diagram displayed
under the Test Connection at the
bottom of page 5 or see illustration
on the right. Connect the female and
male 12V power connectors first then
route the type-c connector to the
designated slot created during the
preparation steps on page 6.
10. Preform the following as listed, see
illustration 10 on the right for reference:
Route the Type-C connector through
A.
the hole created during preparation
on the OEM panel.
B. Second, pass connection through
the HAQ04 bezel.
C. Place direct-Qi bezel onto the OEM
pocket location.
11. Preform the following as listed, see
illustration 11 on the right for reference:
A. Connect the Type-C connector to
the MQUSM.
B. Place the module onto Qi bezel
Notes:
• Hide any excess wiring under the panels
before reassembling.
• Use the provided two-sided adhesives to
secure the panel/module from moving.
12. Lastly, reassemble every1hing in reverse
order, then place your Qi enabled device
onto the HAQ04 assembly to charge
your device. Refer to LED Charging
Status for charging details (page 5).
"Phone NOT included
VEHICLE ASSEMBLY
7
Female Connector to
12V harness connector
Male Connector to
Back of 12V Socket
(MQUSM)
Advertisement
