Ice Maker Cleaning - Hitachi R-SF62EMJ How To Use Manual

MAINTENANCE
Warning

Ice Maker Cleaning

Be sure to check the followings before
starting the operation.
Go to the next step after checking them.
1
Close all the doors.
2
Hold down
alarm sounds.
When the 3 indicator lamps " 急速製冰 (Quick Ice Making) " , " 製冰 (Ice Making) " and " 製
冰停止 (Stop) " start to blink and alarm starts to sound, stop holding the button.
" 製冰機清潔 (Ice Maker Cleaning) " (water supply route) starts (for about 4 minutes).
・ The indicator lamp will flash and the buzzer will sound for about 4 minutes.
・ " 製冰機清潔 (Ice Maker Cleaning) " can ' t be interrupted.
・ If you open any of the refrigerator doors during Ice Maker Cleaning, the cleaning may not
work properly. Do not open or close the door until cleaning is completed.
・Door alarm sounds even if alarm is disabled.
3
Place a clean towel, etc. on the bottom in the Ice Case so that
the cutout of the Ice Case can be blocked after the alarm and
blinking of the indicator lamp end.
Place a water-absorbing towel on the bottom in the Ice Case to prevent trapped water during the ice maker
cleaning from spilling out of the cutout of the Ice Case.
4
Wipe off water inside the Ice Case completely, and then set
it to the Ice Compartment.
Remove the Ice Case, wipe off water inside the Ice Case, and then remove the towel.
There is no problem with using water remaining in the water supply container, if any.
After " 製冰機清潔 (Ice Maker Cleaning) " , it is set to " 製冰 (Ice Making) " mode, etc.
58
(CONTINUED)
● Do not place your hand in the mechanical section
of the automatic ice maker.
(Rotation of the ice tray may cause injury.)
When using for the first time
button for 5 seconds or more until the
Pg.55
When not used for more than one week
Water supply container
・Water is filled in it up to the limit line.
・ It is set correctly beyond the tank
set position line.
Ice case
・If there remains ice, remove it.
It blinks Push it
Cutout
Towel