Table of Contents
Advertisement
3. Software Operation
3.3.2 Output channel switch and operations
"6" area, click on the corresponding channel number in Figure 3.2.2 (CH1, CH2 ......
CH12), you can switch to the corresponding channel to adjust relevant parameters
when changing the channel editing, where there are only 3.2. 2 "4" zone (crossover
and equalization parameters) will vary depending on the channel and change the
parameter values.
3.3.3 Output volume, delay, type, mute and phase setting
In Figure 3.3.1, there are 12 output channels commonly used parameters are
displayed, the user can quickly adjust the parameters directly here. Of course,
users can also customize the horn type of each output channel.
Specifically adjusted as follows:
1．the output volume control, volume control for each channel independently and
the master volume, pushing the volume fader below each channel label can be
in OFF (off), - adjust between 59dB to 6dB; while on the right also has a total
volume of all output is adjustable, adjustment range is OFF (off), - between
-39dB to 6dB.
2．mute and phase adjustment, also under the label of each channel are phase and
mute both buttons select, and click on the button you can be between "positive
phase" and "inverted" Switch, click the mute button You can switch between
"open tone" and "off the sound." Figure 3.3.2 as follows:
3．Select delay units, which are in milliseconds, centimetres, and inches. The range
of milliseconds: 0.000~7.350;Range of mm: 0~254;Range of inches: 0 to 100;
4．DA-12DSP processor output signal path can be any type of configuration
freedom to any sound field point and the speaker type. The system defaults to
4.1 full-range passive mode. Figure 3.3.3 as follows ;
DA-12DSP Special DSP amplifier
12
Figure 3.3.1
Figure 3.3.2
User Manual
Advertisement
Table of Contents
