About Your Projector; Remote Control - Panasonic PT-VW360D Operating Instructions Manual

About your projector

Remote control

1
2
3
4
5
1 Power <v/b> button (v Standby / b Power on)
Sets the projector to the state where the projector is switched
off (standby mode). Also starts projection when the power is
switched off (standby mode).
2 Input selection buttons (<COMPUTER 1> / <COMPUTER 2>/
<HDMI 1/2> / <VIDEO> / <MEMORY VIEWER/USB DISPLAY/
NETWORK>)
Switches the input signal to project. (
3 <MENU> button / <RETURN> button / asqw buttons /
<ENTER> button
Used to navigate through the menu screen. (x page 49)
The asqw buttons are also used to enter password or
characters for [SECURITY].
4 <FREEZE> button
Pauses the projected image and mute the audio temporarily.
(x page 43)
5 Number (<1> - <6>) buttons
Used for entering the ID number in a multiple projector
environment or a password.
6 Remote control signal transmitter
7 <AUTO SETUP> button
Used to perform automatic adjustment while projecting the
image ( Æ page 44).
8 <MUTE> button
Used to mute the audio. ( Æ
9 <AV MUTE> button
Used to turn off the audio and video temporarily. (
Attention
f Do not drop the remote control.
f Avoid contact with liquids.
f Do not attempt to modify or disassemble the remote control.
f Please observe the following contents that are described on
the back of the remote control unit (see the right picture).
g Do not use a new battery together with an old battery.
g Do not use unspecified batteries.
g Make sure the polarities (+ and -) are correct when inserting the batteries.
In addition, please read the contents that are related to batteries in the "Read this first!".
20 - ENGLISH
Chapter 1 Preparation - About your projector
Æ page 40)
page 43)
Æ page 43)
6
7
11
8 12
9 13
10
14
10 <DAYLIGHT VIEW> button
Used to correct the image when the projector is used in a bright
Æ
surroundings. (
11 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
( Æ page 50)
12 <ID SET> button
Sets the projector ID on the remote control for a system using
multiple projectors. (x page 24)
13 <D.ZOOM+> button / <D.ZOOM-> button
Zooms in and out the images. (
14 <VOL+> button / <VOL-> button
Adjusts the volume level of the built-in speaker or the audio
output. ( Æ page 43)
15 <FUNCTION> button
Specifys a shortcut button for a frequently used operation.
Æ
( page 46)
16 <ID ALL> button
Used to simultaneously control all the projectors with one
remote control when using multiple projectors. (x page 24)
17 <P-TIMER> button
Operate the P-TIMER function. (
18 <SCREEN ADJ> button
Corrects the distortion of the projected image. (
15
16
17
18
pages 46, 55)
Æ
page 45)
Æ page 45)
Æ
1.Do not use old battery with new one.
2.Do not use batteries other than the
type specified.
3.Be sure the batteries are inserted properly.
Caution label at the back of the remote control
1. 请勿把旧电池和新电池一起使用。
2. 请勿使用不合规格的电池。
page 44)
Made in China