Powering On/Off; Connecting The Power Cord; Power Indicator - Panasonic PT-VW360D Operating Instructions Manual

Powering on/off

Connecting the power cord

Make sure that the supplied power cord is securely fixed to the <AC IN> terminal of the projector body to prevent
it from being removed easily.
For details of power cord handling, refer to "Read this first!" (x page 4).
Attaching the power cord
1) Check the shapes of the <AC IN> terminal at the rear of the projector and the power cord connector,
and insert the connector completely in the correct direction.
2) Make sure that the tabs on the left and right sides of the connector are securely engaged with the
lugs of the <AC IN> terminal.
Attention
f Do not use the power cord with its tabs damaged. Doing so may result in a poor contact between the power cord connector and the <AC
IN> terminal. Consult your dealer for repairing the power cord.
Removing the power cord
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal of the projector body while pressing the
side tabs.
Attention
f Do not pull out the connector with its left and right tabs engaged with the lugs of <AC IN> terminal. If you pull it out while the tabs are
engaged with the lugs, the tip of the tabs may be damaged. If the tabs are damaged, stop using the projector and consult your dealer for
repair of the power cord.

Power indicator

The power indicator <ON(G)/STANDBY(R)> informs you the status of the power. Confirm the status of the power
indicator <ON(G)/STANDBY(R)> before operating the projector.
Power indicator <ON(G)/STANDBY(R)>
Chapter 3 Basic Operations - Powering on/off
AUTO SETUP
ENGLISH - 35