Faults; Fault Table - Pelgrim NF960RVS Manual

FAULTS

Fault table

Problems with the hob
There is a smell of gas in the
vicinity of the appliance.
A burner does not ignite.
If you are uncertain about whether your appliance is functioning properly,
this does not automatically mean there is a defect. Try to deal with the
problem yourself first by checking the points mentioned below in the
table or visit our website 'www.Pelgrim.nl' for more information.
Possible cause
The appliance connection is
leaking.
Plug not in socket.
Fuse defective/fuse in meter
cabinet switched off.
Spark plug dirty/damp.
Burner parts not correctly
installed.
Burner parts dirty/damp.
Main gas supply valve closed. Open the main gas valve.
Fault in gas mains.
Gas bottle or tank is empty.
Wrong type of gas used.
Control knob not pressed in
far enough.
Solution
Turn off the main gas tap.
Contact your installer.
Insert the plug into the wall
socket.
Replace the fuse or switch on
the fuse in the fuse box.
Clean/dry the spark plug.
Assemble the burner parts
using the centered ridges.
Clean/dry the burner
components. Make sure that
the outflow holes are open.
Consult you gas supplier.
Connect a new gas bottle or
have the tank refilled.
Check whether the gas used
is suitable for the appliance.
Contact your installer if it is
not correct.
Keep the control knob pressed
in far enough between full and
low. This can take longer the
first time because of the gas
supply.
EN 25