Pelgrim NF960RVS Manual page 56

FAULTS
Problems with the hob
The burner does not burn
evenly.
The burner goes out after
igniting.
Problems with the oven
The oven does not switch on.
The oven does not heat up.
The oven does not switch on/
does not heat up.
EN 26
Possible cause
Burner parts not placed
correctly.
Burner parts dirty/damp.
Wrong type of gas used.
Control knob not pressed in
long enough.
Possible cause
It is possible that the digital
timer is programmed. In the
display you will see 'A'.
No temperature set.
The oven door is not closed
(properly).
Solution
Assemble the burner parts
using the centered ridges.
Clean/dry the burner
components. Make sure that
the outflow holes are open.
Check whether the gas used
is suitable for the appliance.
Contact your installer if it is
not correct.
Keep the control knob pressed
in for at least 10 seconds.
Solution
Cancel the program (see
'Turning off the oven in
between uses').
Set the temperature using
the temperature knob (see
'Operating the oven').
Close the oven door.