Faults; Fault Table - Pelgrim IF960MAT Manual

FAULTS

Faults table
Induction hob
Problem
The fan runs on for several
minutes after the hob has been
switched off.
A slight smell is noticeable the
first few times the hob is used.
You can hear a ticking sound in
your hob.
The pans make a noise while
cooking.
You have switched a cooking
zone on but the display keeps
flashing. A pan detection
symbol (u) will appear in the
display.
A cooking zone suddenly
stops working and you hear
a signal.
The hob is not working and
nothing appears in the display.
EN 32
When in doubt about the proper operation of your appliance, this does
not automatically mean there is a defect. Make sure to check the points
mentioned below in the table first, or visit our website www.pelgrim.nl
for more information.
Possible cause
The hob is cooling down.
The new appliance is heating
up.
Ticking can also occur at lower
settings.
This is caused by the energy
flowing from the hob to the
saucepan.
The pan you are using is not
suitable for induction cooking
or has a diameter of less than
14.5 cm.
The preset time has ended.
There is no power supply due
to a defective cable or a faulty
connection.
Solution
Normal operation.
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
Normal operation.
This is caused by the energy
flowing from the hob to the
saucepan. This is not harmful
for the pans or hob.
Use a good pan.
Switch off the signal by
pushing a random key.
Check the fuses or the
electric switch (if there is no
plug).