Using The Usb Memory; Attentions For Use; Usb Memory That Can Be Used With The Projector; Attaching The Usb Memory - Panasonic PT-VZ585N Operating Instructions Manual

Using the USB memory

The projector supports the USB memory installation. When using the Memory Viewer function or the Pairing
function, attach the USB memory to the <USB A (VIEWER)> terminal.
Note
f For information about the Memory Viewer function, refer to "Projecting with MEMORY VIEWER" (
f For information about the pairing between the projector and USB memory, refer to "Using the Pairing function" (
f For the using method of the image transfer application software "Plug and Share", which allows easy wireless connection by pairing the
commercially available USB memory with the projector, refer to the Operating Instructions of "Plug and Share" included in the supplied CD-
ROM. For the pairing between the projector and the USB memory, refer to "Using the Pairing function" (
is to write the image transfer application software "Plug and Share" and the connection information between the projector and the USB
memory to the USB memory.

Attentions for use

Make sure to observe the following.
f Do not disassemble or modify.
f Do not subject the USB memory to strong impact.
f Do not pour liquid such as water on USB memory or get it wet.
f Do not allow foreign objects enter the terminals.
f Do not touch the metal terminals with hands or metal.
f Do not place the USB memory in humid, dusty locations.
f Do not place the USB memory where static electricity or electromagnetic waves are generated.
f Do not place the USB memory within reach of small children.
f If you notice smoke or bad smell, immediately remove the USB memory from the projector and contact the
manufacturer.
f Do not remove the USB memory from the projector while reading or writing data.

USB memory that can be used with the projector

The projector supports commercially available USB memory formatted with FAT16 or FAT32.
Note
f USB memory with security function enabled cannot be used for pairing.
f To use the Pairing function, at least about 30 MB of free space is required in the USB memory.

Attaching the USB memory

1) Attach the USB memory firmly into the <USB A (VIEWER)> terminal.
Attention
f Pay attention to the terminal direction to avoid damaging the terminal when attaching the USB memory.
f Attach the USB memory directly into the <USB A (VIEWER)> terminal of the projector. Do not use a USB extension cable or USB hub.
Note
f You can attach the USB memory even when the projector is turned on.
f When using the Pairing function, the pairing data is written into the USB memory. If the USB memory has a write-protect switch, make sure
the USB memory is writable.

Removing the USB memory

1) Make sure that the indicator on the USB memory is not blinking, and remove it.
Attention
f When the indicator of the USB memory attached to the projector is blinking, it indicates that the projector is accessing (reading or writing
into) the USB memory. Do not remove the USB memory from the projector while the indicator is blinking.
f When using a USB memory that does not have a monitor function such as an indicator, you cannot check the access status to the USB
memory. In this case, wait until one of the following is completed and then remove the USB memory.
g Turn off the projector.
g When using the Memory Viewer function, switch to the input other than MEMORY VIEWER.
g When using the Pairing function, wait for the write completion message of the pairing data to be displayed on the idle screen.
Chapter 3 Basic Operations - Using the USB memory
Æ page 140).
Æ
page 147).
Æ page 147). The pairing process
ENGLISH - 55