Replacement - Panasonic PT-VZ585N Operating Instructions Manual

Replacement

Lamp unit
The lamp unit is a consumable component. Refer to "When to replace the lamp unit" (
about the replacement cycle.
When purchasing the optional Replacement Lamp Unit (Model No.: ET-LAV400), consult your dealer.
It is recommended to replace the lamp unit by a professional technician. Consult your dealer for details.
Warning
Replace the lamp unit after the lamp has cooled (after waiting at least one hour).
The high temperature inside the cover will cause burns.
Notes on the replacement of the lamp unit
f A Phillips screwdriver is required when replacing the lamp unit.
f Since the luminous lamp is made of glass, it may burst if dropped or hit with a hard object. Handle with care.
f Do not disassemble or modify the lamp unit.
f When replacing the lamp unit, be sure to hold it by the handle because its surface is pointed and its shape is
protruded.
f The lamp may rapture. Replace the lamp unit carefully so that the glass fragments of the lamp do not scatter.
While attaching the projector to the ceiling, do not work right under the lamp unit or do not conduct work while
your face is near the lamp unit.
f The lamp contains mercury. When disposing of used lamp units, contact your local authorities or dealer for
correct methods of disposal.
Attention
f Panasonic takes no responsibility for any damage or malfunction of the product resulting from use of lamp units which are not manufactured
by Panasonic. Use only specified lamp units.
Note
f The model numbers of accessories and optional accessories are subject to change without prior notice.
When to replace the lamp unit
The lamp unit is a consumable component. Since its brightness gradually decreases over time, it is necessary to
replace the lamp unit regularly. The estimated duration before replacement is 5 000 hours, but the lamp may go
off before reaching to 5 000 hours, depending on the characteristics of the individual lamp, usage conditions, and
the installation environment. It is recommended that the Replacement Lamp Unit be prepared earlier.
If you continue to use the lamp unit after 5 000 hours has elapsed, the lamp turns off automatically after approximately
10 minutes, as it may cause malfunction of the projector.
The message is displayed for 30 seconds. If you press any button
Over 4 800 hours on the control panel or the remote control within 30 seconds, the
message disappears.
Over 5 000 hours The message remains displayed until you press any button.
Note
f To predict the lamp unit replacement time, convert the runtime of [NORMAL], [ECO1] and [ECO2], which are set from the [PROJECTOR
SETUP] menu → [LAMP POWER], to the equivalent runtime of [[NORMAL] respectively. After checking the runtime of [NORMAL], [ECO1]
and [ECO2] displayed in the [PROJECTOR SETUP] menu → [STATUS] → [RUNTIME] → [LAMP (ET-LAV400)], calculate the converted
runtime by referring to "Formula for lamp unit replacement time (rough estimate)". (
f The lamp unit replacement time of 5 000 hours is a rough guideline instead of a guarantee.
154 - ENGLISH
Chapter 6 Maintenance - Maintenance/replacement
On-screen display
REPLACE LAMP
Æ
page 154) for details
Lamp indicator <LAMP>
Lights in red (even in stand-by mode).
Æ page 87)