Memory Viewer Function; What You Can Project With The Memory Viewer Function; Cautions On Using Usb Memory - Panasonic PT-VX605N Operating Instructions Manual

Memory Viewer function

The Memory Viewer function makes it is possible to project the video or still image stored in the USB memory.

What you can project with the Memory Viewer function

Memory Viewer function supports the following files.
Extension
mov
avi
Video
mp4
mpg/mpeg
wmv
Extension
jpg/jpeg
Still image
bmp
Note
f The maximum size of file is 2 GB.
The maximum number of folder/file is up to 1 000. If it exceeds the folder/file cannot display and an error message appears.
f It maybe impossible to play even if the file is recorded in the supported format.

Cautions on using USB Memory

Please observe the following.
f Do not put USB memory or its cap within close reach of children. Swallowing them may cause suffocation.
f If the smoke or questionable odor rise, remove the USB memory from the projector, and then contact your dealer.
f Do not put water, chemical or oil to the USB memory. It may cause short out or fire.
f Do not put foreign objects or put metal objects to the USB terminal. Static electricity may cause data loss or data corruption.
f Do not remove the USB memory from the computer or the projector while the USB memory is reading out or writing the data.
It may cause data loss or data corruption.
f Do not store the USB memory where high temperature, humid or dusty place or magnetized items are around.
Note
f It is compatible with the USB memory sold in the market.
f It cannot be used the other format other than the formatted with FAT16 and FAT32.
Inserting the USB memory
1) Insert the USB memory directly into the <USB A (VIEWER)> terminal.
Attention
f When inserting the USB memory, confirm the direction of the plug and do not damage the terminal.
Removing the USB memory
1) Make sure that the USB memory is not flashing, and then unplug it.
Attention
f Please note following points when removing the USB memory.
- The indicator of the USB memory is blinking means that the projector is reading out the data. Do not remove the USB
memory while it is blinking.
- When using a USB memory without an indicator, you cannot recognize when the projector reading out the data. Please
remove it from the projector after closing the memory viewer function or turning off the projector.
- Do not insert and remove the USB memory in a short time. Remove the USB memory at least 5 seconds after inserting.
And insert it at least 5 seconds after removing. When inserting or removing the USB memory, the projector takes about 5
seconds to identify the operation.
Chapter 5 Operation of Function - Memory Viewer function
Video codec
H.264/AVC
MotionJpeg
H.264/AVC
MotionJpeg
Mpeg4
H.264/AVC
Mpeg4
Mpeg2
WMV9
Maximum resolution: 8 000 x 8 000
Maximum resolution: 2 000 x 2 000
support: 1, 4, 8, 16, 24, 32 bit
Audio codec Video format
AAC
Linear PCM
mp3
AAC
Maximum:
Linear PCM
1 920 x 1 080/30 fps
AAC
Mpeg4 AAC-LC
Mpeg1 Layer2
WMA
Format
Audio format
Maximum:
48 kHz 2 ch
(It is up to 16 kHz
stereo when the codec
is linear PCM)
ENGLISH - 119