About Miracast - Panasonic PT-VX605N Operating Instructions Manual

About Miracast

This function is to project the displayed images on the Miracast-certified device to the projector through the wireless LAN
connection.
Connecting with the Miracast certified-device
1) Press the <Miracast> button on the remote control.
f Switch the Miracast input, and the Miracast idle screen will display.
f You can also select the Miracast input by pressing the <INPUT SELECT> button on the control panel.
2) Start the Miracast application of the correspondent Miracast devices and PC.
f Check the projector name/ network ID/ the MAC address of the wireless LAN which is displayed on the Miracast idle
screen, and then select the device name on the Miracast application.
3) Press qw to select [OK] on the confirmation screen of the connected device, then press the <ENTER>
button.
f The screen of the connected device is displayed.
Note
f The Miracast application name and starting method differs from devices.
f For the operation of the Miracast application, refer to the operation instructions of the device.
Disconnecting with the Miracast certified-device
Close the Miracast application of the device. And then the Miracast idle screen will be projected.
If you disconnect the device forcibly without closing the application, such as turning off the power of the device, it may take a
longer time to display the Miracast idle screen.
Note
f Miracast is a system that has been standardized by Wi-Fi Alliance, it is possible to display the copyright protection content
(HDCP-encrypted DVD etc.).
f When connected with Miracast, the volume cannot be adjusted by pressing the <VOL-/VOL+> buttons on the remote control.
f The Miracast function is disabled when the [WIRELESS LAN] menu is set to [DISABLE] (x page 90).
f The character after the space will not be displayed on the Miracast-certified device when the space is used in [NAME
CHANGE].
Chapter 5 Operation of Function - About Miracast
Miracast idle screen
ENGLISH - 125