Notes On Using Wireless Connection - Panasonic PT-VX605N Operating Instructions Manual

Notes on Using Wireless Connection

Wireless connection function of the projector uses radio waves in the 2.4 GHz / 5 GHz band.
A radio station license is not required, but be sure to read and fully understand the following items before use.
r Do not use near other wireless equipment.
The following equipment may use radio waves in the same band as the projector.
When the projector is used near these devices, radio wave interference may make communication impossible, or the
communication speed may become slower.
f Microwave ovens, etc.
f Industrial, chemical and medical equipment, etc.
f In-plant radio stations for identifying moving objects such as those used in factory manufacturing lines, etc.
f Designated low-power radio stations
r If at all possible, avoid the use of cellular phones, TV sets or radios near the projector.
Cellular phones, TV sets, radios and similar devices use different radio bands from the projector, so there is no effect on
wireless communication or the transmission and reception of these devices. However, radio waves from the projector may
produce audio or video noise.
r Wireless communication radio waves cannot penetrate steel reinforcements, metal, concrete, etc.
Communication is possible through walls and floors made from materials such as wood and glass (except glass containing
wire mesh), but not through walls and floors made from steel reinforcements, metal, concrete, etc.
r Avoid using the projector in locations prone to static electricity.
If the projector is used in a location prone to static electricity, such as on a carpet, the wireless LAN or wired LAN
connection may be lost.
If the static electricity or noise make it impossible to establish a connection with the LAN, please press the power button on
the remote control or the control panel to power off the projector, and eliminate the source of static electricity or noise, then
turn on the projector.
r Using the projector outside the country
It is forbidden to take the projector outside the country or region where you purchased it, so use it only in the said country
or region. Also, note that depending on countries or regions there are restrictions on the channels and frequencies at which
you can use the wireless LAN.
r Available wireless LAN channels
The channels (frequency range) that can be used differ according to the country or region. Refer to the table below.
Country or region
North America
Other counties
 The frequency and channel differ depending on the country.
 The passive scanning is performed by changing radio to the channel being scanned in each country.
 Please use the wireless LAN feature in compliance with the laws of each country.
z For North America
This device is restricted to indoor use when operated in the 5.15 to 5.25 GHz frequency range (Channels 36 to 48).
z For EU
This device is restricted to indoor use when operated in the 5.15 to 5.35 GHz frequency range (Channels 36 to 64).
20 - ENGLISH
Chapter 1 Preparation - Precautions for use
Standard Channels used
IEEE802.11b/g/n
36 / 40 / 44 / 48 channel
52 / 56 / 60 / 64 channel
100 / 104 / 108 / 112 / 116
IEEE802.11a/n
/ 132 / 136 / 140 channel
149 / 153 / 157 / 161 / 165
IEEE802.11b/g/n Passive scanning
IEEE802.11a/n Passive scanning
Frequency band (Center frequency)
1 - 11 channel
(except 5.600 GHz - 5.650 GHz)
channel
2.412 GHz - 2.462 GHz
5.180 GHz - 5.240 GHz
5.260 GHz - 5.320 GHz
5.500 GHz - 5.700 GHz
5.745 GHz - 5.825 GHz
2.412 GHz - 2.472 GHz
5.180 GHz - 5.850 GHz