If Your Literider Does Not Operate - Golden LiteRider GL111 Owner's Manual

IF YOUR LiteRider™ DOES NOT OPERATE
• Make certain that the freewheel lever is set to the engaged position. See page 19.
• Check the main circuit breaker. If necessary, reset the circuit breaker. See #1 on figure
27.
• Make certain that the speed adjustment dial is at the desired setting.
• Make certain that the key switch is set to the "On" position.
If none of the above procedures solve the problem, contact your authorized Golden
Technologies, Inc. provider.
MAIN CIRCUIT BREAKER
The main circuit breaker reset button is
located on the side of the battery pack. See #1 on
figure 27.
WARNING! Do not attempt electrical repairs.
Consult Golden Technologies, Inc. or your
authorized Golden Technologies, Inc. provider.
If, for no apparent reason, your LiteRider stops
operating, the main circuit breaker may have
tripped.
Possible causes for the main circuit breaker to trip:
• Driving up a long, steep hill.
• Driving over a curb.
• Run-down batteries.
• Exceeding the maximum weight capacity of the scooter.
As you operate your LiteRider, battery voltages go down and battery current must rise to
satisfy the demands of the motor and of other electrical devices operating on your
scooter. This can cause a heavy current draw that will trip the main circuit breaker.
Remedy:
• Recharge your LiteRider's batteries. See "Charger and Batteries" in this section of this
manual.
• If the problem continues, have your authorized Golden Technologies, Inc. provider load
test the batteries.
• If the batteries are good, the charger may be the problem. Consult your authorized
Golden Technologies, Inc. provider.
X. CARE AND MAINTENANCE
Figure 27. Main Circuit Breaker
33
1