Golden LiteRider GL111 Owner's Manual page 28

Reinstall the Drivetrain
1. Line up the two yellow tabs on the frame, with the two grooves on the drivetrain, one
on each side of the scooter. See figure 20.
WARNING! WATCH FINGER PLACEMENT! BE CAREFUL NOT TO PINCH YOUR
FINGERS!
2. Lower the frame onto the drivetrain until the drivetrain release lever engages. You
should hear an audible click.
Figure 20. Drivetrain Alignment
Install the Battery Pack
3. Gently lower the battery pack onto the frame. See figure 21.
When installing the battery pack for the first time,
you must first remove the two blocks located underneath the
battery pack. The scooter will not power on if the deactivate
blocks are installed.
Raise the Tiller
4. Loosen the tiller adjustment knob and raise the tiller.
See #1 on figure 22.
5. Tighten the tiller adjustment knob at the desired position.
– MAKE SURE YOU TIGHTEN YOUR TILLER KNOB TO BE SURE IT IS
SECURED IN THE DESIRED POSITION!
VIII. ASSEMBLY
1
2
Figure 22. Tiller Raised and Unlocked
Figure 21. Battery Pack Installation
28
Deactivate Block