Subscribe to Our Youtube Channel
Related Manuals for Ducar DLG2000iS
Summary of Contents for Ducar DLG2000iS
- Page 1 Model: DLG2000iS Portable Inverter Generator OPERATOR’S MANUAL To reduce the risk of injury, the user must read and understand the operator's manual before using this product. SAVE THIS MANUAL FOR FUTURE REFERENCE...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction.................................... 3 ..................................3 Safety Rules ................................... 4 Safety Symbols................................4 Safety Instructions ..............................4 Features....................................7 Control Panel Functions ............................... 8 ON/OFF Start Switch and Choke..........................8 Indicator Lights................................8 Engine Economy Control ............................9 Parallel Outlets. -
Page 3: Introduction
The emissions control system for this generator is compliant with all standards set by the Environmental Protection Agency. Record the following information bellow for service or warranty assistance. Date of Purchase Model Number Serial Number Warranty Ducar power products are covered by a one-year limited consumer warranty. -
Page 4: Safety Rules
SAFETY RULES Safety Symbols Indicates a hazardous situation WARNING! which could result in serious injury or death if not avoided. Indicates a hazardous situation CAUTION! which could result in damage to equipment or property. Toxic Fumes Risk of explosion Risk of electric shock Hot surface Safety Instructions the user must understand and follow all manual instructions and use common sense. - Page 5 SAFETY RULES Never exceed generators wattage / amperage capacity. This could damage the generator WARNING! and / or connected electrical devices. • Check operating voltage and frequency requirements of all electrical devices prior to plugging them into the generator. Never start or stop engine with electrical devices plugged in to the receptacles. Failure to WARNING! do so could damage the generator and / or connected electrical devices.
- Page 6 SAFETY RULES This generator produces a very high voltage which could result in burn or WARNING! electrocution causing serious injury or death. • Never handle the generator, electronic devices,or any cord while standing in water, while barefoot, or when hands or feet are wet.
-
Page 7: Features
FEATURES... -
Page 8: Control Panel Functions
CONTROL PANEL FUNCTIONS Fuel Selector Switch When the Switch is in the petrol position and the petrol is "On", the generator is ready to start on petrol. When the Switch is in the LPG position and the petrol is "Off" and generator is ready to start on LPG. -
Page 9: Engine Economy Control
CONTROL PANEL FUNCTIONS Note: The engine overload indicator light may turn on for a few seconds when attaching a load due to a power surge. This is normal. AC Pilot Indicator Light The green AC Pilot Indicator Light comes on when the engine starts and generates power. Oil Warning Overload AC Pilot... -
Page 10: Parallel Outlets
CONTROL PANEL FUNCTIONS Parallel Outlets Located just above the Ground Terminal, the generator’s Parallel Outlets enable a user to run two P2000 generator’s simultaneously. This operation requires special cables. When operating parallel generators, the rated output is 3.0kVA and the rated current is 13.9A/230VAC. For cables and instructions consult your dealer for a PARALLEL OPERATION C C C ABLE KIT. -
Page 11: Assembly
ASSEMBLY Connecting Generator to an Electrical System • If connecting generator to a building’s electrical system for standby power, The power from the generator must be isolated from the circuit breaker or alternative power source. The connection must comply with all electrical UNPLUG codes and applicable laws. -
Page 12: Adding / Checking Oil
ASSEMBLY Adding / Checking Engine Oil • Place generator on a level surface. • Remove screws and then remove the maintenance cover. • Remove the crankcase dipstick. • Insert a funnel into the crankcase dipstick hole and carefully add the specified amount of W- 0 engine oil until the oil reaches the outer edge of the oil fill hole (crankcase dipstick hole). -
Page 13: Grounding The Generator
OPERATION Grounding the Generator To avoid electrocution, this generator must be properly grounded prior to use. For instructions see Control Panel Functions pg.10. How to Start Engine on Petrol • Place generator on a level surface. All electrical loads MUST be disconnected from generator. •... -
Page 14: How To Stop Engine
OPERATION How to Stop Engine • Turn the Economy switch to the “OFF” position. • Disconnect any electronic device. All loads MUST be disconnect from the generator. Never start or stop the engine with electrical devices plugged in to the sockets. •... -
Page 15: Ac Parallel Operation
OPERATION AC Parallel Operation It is possible to connect two P2000i to each other, using a parallel cable kit, to increase available power output. • Connect PARALLEL OPERATION CABLES to two P2000i generators according to the instructions provided with the cable kit. -
Page 16: Don't Overload Generator
OPERATION Don’t Overload Generator Make sure you can supply enough rated watts for all electronic devices connected to the generator. Rated watts refer to the power a generator must supply to keep a device running. Surge watts refer to the power a generator must supply to start an electronic device. -
Page 17: Maintenance
MAINTENANCE Regular maintenance will extend the life of this generator and improve its performance. The warranty does not cover items that result from operator negligence, misuse, or abuse. To receive full value from the warranty, operator must maintain the generator as instructed in this manual, including proper storage. Before inspecting or servicing this machine, make sure the engine is off and no parts are WARNING! moving. -
Page 18: Checking Spark Plug
MAINTENANCE Checking Spark Plug • Remove cap. Then remove spark plug cap. • Disconnect the spark plug wire from the spark plug. • Before removing the spark plug, clean the area around its base to prevent debris from entering the engine. •... -
Page 19: Changing Oil
MAINTENANCE Changing Oil • Place generator on a level surface. • Run the generator for several minutes until the engine is warm. Turn off generator. • Remove screws, then remove the maintenance side cover. • Remove the crankcase dipstick. • Place an oil pan underneath the engine. -
Page 20: How To Clean Air Filter
MAINTENANCE Air Filter Wash the foam element in soapy water and let dry. Pour a small amount of oil on the foam element then squeeze out, but do not wring out, excess oil. Foam element should be damp, but not dripping. •... -
Page 21: How To Clean Fuel Filter
MAINTENANCE Fuel Tank Filter • • • • • Install fuel cap. Fuel Filter • To clean, remove screws, remove outer casing, and drain fuel. • Lift and hold onto the clamp, then remove hose from tank. • • • •... - Page 22 MAINTENANCE Contact with a hot engine or exhaust system can cause serious burns or fires. Let the engine WARNING! cool before transporting or storing the generator. Take care not to drop or strike the generator when transporting. Do not place heavy objects on CAUTION! the generator.
-
Page 23: Troubleshooting
TROUBLESHOOTING Problem Cause Solution Generator is running but does 1. DC Circuit Breaker is “OFF”. 1. Turn DC Circuit t B reaker “ON” not supply power. 2. Green AC Pilot Light Indicator is off. 2. Stop engine and restart. 3. Poor connection. 3.
Need help?
Do you have a question about the DLG2000iS and is the answer not in the manual?
Questions and answers