Advertisement
W O L F
T R O U B L E S H O OT I N G
T R O U B L E S H O OT I N G
P R O B L E M
Burner will not light
Burner lights with
match, but will not light
with ignition button
Yellow flame
Incomplete burner flame
Flame blows out in
the wind
Burner pops and
blows out
Lack of heat
Too much heat
Excessive flare-up
Uneven heat
Dimensions in parentheses are in
millimeters unless otherwise specified.
G U I D E
G U I D E
P R O B A B L E C A U S E
Lack of gas or crimped hose.
Blockage in burners, burner
ports, orifice/valve or hose.
Regulator failure.
Improper burner location/
venturi not over orifice.
No spark.
Battery dead.
Obstructed burner causing
lean fuel mixture.
Broken ignition electrode.
Damaged ignition or wire.
If a spark appears in the box,
the ignition system is operating.
No spark, terminal disconnected
from electronic ignition.
Battery dead.
Rich air mixture.
Broken ignition electrode.
Clogged, broken or
worn-out burner.
Plugged orifice.
Lack of gas supply.
Partly clogged orifice or
burner tube.
Broken burner or
fuel mixture too lean.
Partly blocked orifice or burner.
Low gas or dirty regulator vent.
Incorrectly installed radiant.
Damaged orifice or no orifice.
Unauthorized regulator
adjustment.
Incorrectly installed radiant.
Build-up of grease on
internal parts.
Overload from fatty meats or
excessive cooking temperature.
Improper radiant orientation.
P O S S I B L E S O L U T I O N
Check air shutter adjustment,
(see page 8).
Check gas supply.
Clean orifice and burner.
Check regulator to be sure vent
hole points down, (see page 8).
Check igniter battery.
Clear burner obstruction.
Check igniter battery.
Check air shutter adjustment,
(see page 8).
Needs cleaning. Check air shutter
adjustment, (see page 8).
Check orifices.
Check gas supply.
Clean orifice and burner.
Provide a wind break.
Check burners and air shutter
adjustment, (see page 8).
Clean orifice and burner.
Check gas supply.
Verify triangle cut-out is
toward back.
Check orifices.
Check regulator adjustment.
Verify that triangle cut-out is
toward back.
Clean internal parts, including
grill tank bottom.
Check for correct radiant
orientation.
21
Advertisement
