Table of Contents
Advertisement
Command table
Available features differ by projector specification, input sources, settings, etc..
Commands are working if the standby power is 0.5W or a supported baud rate of the projector is set.
Uppercase, lowercase, and a mixture of both types of characters are accepted for a command.
If a command format is illegal, it will echo Illegal format.
If a command with correct format is not valid for the projector model, it will echo Unsupported item.
If a command with correct format cannot be executed under certain condition, it will echo Block item.
If RS232 control is performed via LAN, a command works whether it starts and ends with <CR>. All the commands and
behaviors are identical with the control through a serial port.
Function
Type
Write
Power
Write
Read
Write
Write
Write
Write
Write
Write
Write
Write
Write
Source Selection
Write
Write
Write
Write
Write
Write
Write
Write
Read
Write
Write
Read
Audio Control
Write
Write
Write
Operation
Power On
Power off
Power Status
COMPUTER/YPbPr
COMPUTER 2/YPbPr2 <CR>*sour=RGB2#<CR>
COMPUTER 3/YPbPr3 <CR>*sour=RGB3#<CR>
Component
Component2
DVI-A
DVI-D
HDMI(MHL)
HDMI 2(MHL2)
Composite
S-Video
Network
USB Display
USB Reader
HDbaseT
DisplayPort
3G-SDI
Current source
Mute On
Mute Off
Mute Status
Volume +
Volume -
Volume level for
customer
ASCII
<CR>*pow=on#<CR>
<CR>*pow=off#<CR>
<CR>*pow=?#<CR>
<CR>*sour=RGB#<CR>
<CR>*sour=ypbr#<CR>
<CR>*sour=ypbr2#<CR>
<CR>*sour=dviA#<CR>
<CR>*sour=dvid#<CR>
<CR>*sour=hdmi#<CR>
<CR>*sour=hdmi2#<CR>
<CR>*sour=vid#<CR>
<CR>*sour=svid#<CR>
<CR>*sour=network#<CR>
<CR>*sour=usbdisplay#<CR>
<CR>*sour=usbreader#<CR>
<CR>*sour=hdbaset#<CR>
<CR>*sour=dp#<CR>
<CR>*sour=sdi#<CR>
<CR>*sour=?#<CR>
<CR>*mute=on#<CR>
<CR>*mute=off#<CR>
<CR>*mute=?#<CR>
<CR>*vol=+#<CR>
<CR>*vol=-#<CR>
<CR>*vol=value#<CR>
8
Support
Yes
Yes
Yes
Yes
Yes
No
No
No
No
No
Yes
Yes
Yes
Yes
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Advertisement
Table of Contents
