Command table
• Available features differ by projector specification, input sources, settings, etc..
• Commands are working if the standby power is 0.5W or a supported baud rate of the projector is
set.
• Uppercase, lowercase, and a mixture of both types of characters are accepted for a command.
• If a command format is illegal, it will echo Illegal format.
• If a command with correct format is not valid for the projector model, it will echo Unsupported
item.
• If a command with correct format cannot be executed under certain condition, it will echo Block
item.
• If RS232 control is performed via LAN, a command works whether it starts and ends with <CR>. All
the commands and behaviors are identical with the control through a serial port.
Function
Power
Source
Selection
Type
Operation
Write
Power On
Write
Power Off
Read
Power Status
Write
COMPUTER/YPbPr
Write
COMPUTER
2/YPbPr2
Write
COMPUTER
3/YPbPr3
Write
Component
Write
Component2
Write
DVI-A
Write
DVI-D
Write
HDMI(MHL)
Write
HDMI 2(MHL2)
Write
Composite
Write
S-Video
Write
Network
Write
USB Display
Write
USB Reader
Write
HDBaseT
Write
DisplayPort
Write
3G-SDI
Write
Smart System
ASCII
<CR>*pow=on#<CR>
<CR>*pow=off#<CR>
<CR>*pow=?#<CR>
<CR>*sour=RGB#<CR>
<CR>*sour=RGB2#<CR>
<CR>*sour=RGB3#<CR>
<CR>*sour=ypbr#<CR>
<CR>*sour=ypbr2#<CR>
<CR>*sour=dviA#<CR>
<CR>*sour=dvid#<CR>
<CR>*sour=hdmi#<CR>
<CR>*sour=hdmi2#<CR>
<CR>*sour=vid#<CR>
<CR>*sour=svid#<CR>
<CR>*sour=network#<CR> NO
<CR>*sour=usbdisplay#<
CR>
<CR>*sour=usbreader#<C
R>
<CR>*sour=hdbaset#<CR> NO
<CR>*sour=dp#<CR>
<CR>*sour=sdi#<CR>
<CR>*sour=smartsystem#
<CR>
8
support
YES
YES
YES
NO
NO
NO
NO
NO
NO
NO
YES
YES
NO
NO
NO
NO
NO
NO
NO