Titan XL255 Owner's Manual page 12

Spraying Troubleshooting -
The filter must be cleaned every time you use your sprayer. When using thicker spray materials, the filter might need to
be cleaned more often.
NOTE - the LX60 threads are left-handed. Turn the filter
clockwise to remove, and counterclockwise to replace.
1. Perform Pressure Relief Procedure, page 7.
2. Unclip the trigger guard from the filter housing by pulling
outward from the filter housing. Unscrew the filter
housing.
3. Remove the filter from the spray gun housing and clean
with the appropriate cleaning solution (warm, soapy
water for latex paints, mineral spirits for oil-based
materials). For spray gun model LX60, the filter will
need to be unscrewed from the gun housing (turn
clockwise).
4. Inspect the filter for holes (see inset, right). Replace if
holes are found.
nOTE - nEVER POKE THE FILTER WITH A SHARP
InSTRuMEnT!
5a. Model LX05 - Replace the cleaned filter, tapered
end first, into the gun housing. The tapered end of
the filter must be loaded properly into the gun.
Improper assembly will result in a plugged tip or no
flow from the gun.
5b. Model LX60 - Screw the tapered end of the filter into the
gun housing (turn counterclockwise to tigthen).
6. Reassemble the spray gun.
Spraying Troubleshooting -
The screen at the bottom of the suction tube may also need cleaning. Check it every time you change spray containers.
1. Remove the filter by unscrewing it from the suction tube.
Clean the filter with the appropriate cleaning solution
(warm, soapy water for latex materials, mineral spirits for
oil-based materials).
2. Thread the filter back into place.
If after completing all of the steps in Spraying
Troubleshooting you are still experiencing problems
spraying, refer to the Troubleshooting section (page 22).
English
Cleaning the Spray Gun Filter
Trigger Filter
guard
Filter
Trigger
guard
housing
Cleaning the Inlet Filter
12
Spray gun
model LX05
Tapered
end
(filter top)
Hole
Filter
housing
Spray gun
model LX60
Threaded
end
(filter top)
Hole
Filter