Optoma W515T Manual page 48

Sleep Timer (min)
Sets the countdown timer interval. The countdown timer will start, with or
without a signal being sent to the projector. The projector will automatically
power off when the countdown has finished (in minutes).
Quick Resume
If the projector is accidentally turned off, this feature allows the projector to
be instantly powered on again within 100 seconds of power down.
Power Mode (Standby)
Set whether the VGA-OUT function works when the projector is in standby
(powered off but connected to AC power).
Eco: The VGA-OUT and AUDIO-OUT functions will not work when the
projector is in standby.
Active: The VGA-OUT and AUDIO-OUT functions will work when the
projector is in standby.
Note
When Power mode (Standby) is set to Eco (<0.5W), the VGA output, Signal Power On,
Audio pass-through will be deactivated when the projector is in standby.
Lamp Settings
Lamp Hours
Display the projection time.
Lamp Reminder
Choose this function to show or to hide the warning message when the
changing lamp message is displayed.
Brightness Mode
Bright: Choose "Bright" to increase the brightness.
Dynamic: Choose "Dynamic" to dim the lamp power which will be based
on brightness level of the content and adjust lamp power consumption
between 100% and 30% dynamically. The lamp life will be extended.
Eco+: Choose "Eco+" to dim the lamp power which will be based on
brightness level of the content and adjust lamp power consumption
between 80% and 30% dynamically. The lamp life will be extended.
Lamp Reset
Reset the lamp hour counter after replacing the lamp.
Optional Filter Settings
Optional Filter Installed
Choose "Yes" if an optional dust filter is installed.
Filter Usage Hours
Display the dust filter's elapsed operating time (in hours).
EN-48