Configuring Your Remote Control - JVC LT-37DV1BJ Instructions Manual

Configuring your remote control

You can configure your TV's remote control to operate your other devices.
Setting your remote

Turn on the device manually.

Switch the remote control mode to a mode
that matches your device. Refer to the
table on the right to select an appropriate
mode.
The indicator lights for 3 seconds each time the

remote control is operated.

Find the remote control code for your
device according to its brand from the
"Remote control codes" list. (Refer to
P. I - XII at the back of this manual.)
TV STB
AUDIO BD/DVD
Getting started

Set the remote control code.
Press and hold
The indicator will unlit for a second after entering the four digit remote

control code number.

Point the remote control at your device, press
confirm that your device is turned off. If your device does
not respond, try entering another available code.
Note
If your device does not respond, try all the available codes for the device's

brand.
If none of the code works, or the brand is not listed, refer to "Using the

search code function" (P. 29).
MODE
TV JVC brand only
STB Cable Set Top Box, Cable/PVR Combination,
Satellite Set Top Box, SAT/PVR Combination
BD/DVD DVD, Blu-Ray DVD, HD DVD, DVD-R, Home
Theater in Box, TV/DVD Combination
AUDIO Amplifier, Receiver, Home Theater in Box
Basics Advanced
Enter four digit Release the button
number
Applicable devices
Etc.
and